3 Easy Steps to Build Your Fulldive Controller
Fulldive Corp 2017
Step 1: Print out letter sized Page R and L. You do not need to trim the borders. Step 2: Follow the instructions below to assemble your paper controller. a1. Lay Page R face down and add an additional piece of paper on top.
a2. Fold the paper twice according to the printed instructions.
a3. Flip the folded paper faced down and staple according to the marks.
Scrap paper R
rt se In b um th
Page R
b1. Lay Page L face down and add an additional piece of paper on top.
b2. Fold the paper twice according to the printed instructions.
b3. Flip the folded paper faced down and staple according to the marks.
b4. With both s faced down, tape the two surfaces together.
tr
es nI
L
Scrap paper
bm uh t
Page L
Step 3: That’s it! Launch Fulldive, make sure
is checked and do the following.
c1. Insert your thumb in the right to hold the controller.
c2. Hold up your controller with left lowered at 45 degrees.
Make sure patterned side faces up.
Hold within your phone camera view. L
R
R
fulldive.com
fulldive.com
fulldive.com
Insert thumb
Insert thumb
Insert thumb
I re sn tt bm uh
bm uh
tt
re sn I
L
R
c3. To click, quickly tap your fingers to lift up the left .
Step 3. Staple
Page R
R
Staple
Staple
Staple
Insert thumb
Step 2. Mountain fold
Step 2. Valley fold
Step 1. Mountain fold
fulldive.com
Step 3. Staple
Page L
L Staple
Step 2. Valley fold
Step 1. Mountain fold
Step 2. Mountain fold
Staple
Staple