Kupdf.net_dielectric-strength-astm-d149-iec-60243.pdf 4e264x

10/12/2014

Dielectric Strength ASTM D149, IEC 60243

You are here: Home > Services > Polymers and Plastics > Testlopedia > Dielectric Strength ASTM D149, IEC 60243

Services

Dielectric Strength ASTM D149, IEC 60243

Polymer and Plastic Services

Send us a request

E-mail Us

web.-a pa c@i ntertek.com

Polymer Testing Laboratory Call Us Testlopedia - The Plastics Testing Encyclopedia +65 6322 8228 Analytical Testing of Polymers Composites Testing Show other conta cts Tensile Testing Scope: Shear Testing Dielectric Strength is a measure of the electrical Adhesive Testing strength of a material as an insulator. Dielectric strength is defined as the Weathering Ageing Testing maximum voltage required to produce a dielectric breakdown through the material Automotive Plastics Testing and is expressed as Volts per unit thickness. A higher dielectric strength represents Packaging Services a better quality of insulator. Chemical Analysis Materials Analysis Test Procedure: Food Services

Dielectric Strength ASTM D149, IEC 60243

Polymer, Plastic Services A-Z

There are three basic procedures that can be used to determine the dielectric strength of an insulator. These procedures are the short-time method, the slow rate-of-rise method and the step-by-step method. Each of these three methods has the same basic set-up, which consists of the test specimen placed between two electrodes in air or oil.

Resources: Reference Gui de to Eva l ua ti ng As s embl y Fa i l ure of Compos i tes a nd Pl a s ti cs

Polymers and Plastics Gl oba l Pol ymers a nd Pl a s ti cs Tes ti ng Pol ymer a nd Pl a s ti c Servi ces A-Z

For the most common test, the short-time method, voltage is applied across the two electrodes and raised from zero to dielectric breakdown at a uniform rate. Breakdown is when an electrical burn-through punctures the sample, or decomposition occurs in the specimen. The rate of voltage rise is determined by the time it takes the sample to reach dielectric breakdown. The slow-rate-of rise method starts at 50% of the breakdown voltage as determined by the short-time-method and is increased at a uniform rate. The step-by-step method starts at 50% of the short-time-test then voltage is increased at equal increments for a specified time period until breakdown. The test is sometimes performed in oil to prevent arcing from the electrode to the ground. Specimen size: The recommended specimen type for this test is a 4 inch plaque or larger. Any specimen thickness can be used; however the most common thickness is between 0.8 to 3.2 mm (0.032 to 0.125 inch). Specimens over 2 mm thick are typically tested in oil to decrease the chance of flashover before breakdown. Data: Dielectric strength is calculated by dividing the breakdown voltage by the thickness of the sample. The data is expressed in Volts/mil. The location of the failure is also recorded. A higher dielectric strength represents a better quality of insulator. **Please note that this test description is intentionally generic in nature and aimed at providing a descriptive summary to enhance test understanding. Due to copyright restrictions, we are not able to provide copies of standards. Standards can be obtained from appropriate standards authorities. Testlopedia - The Plastics Testing Encyclopedia Dielectric Constant and Dissipation Factor Surface Resistivity, Volume Resistivity, ASTM D257, IEC 60093 Request more information to see how Intertek can help your organization with Dielectric Strength ASTM D149, IEC 60243.

© Intertek Group plc.

Disclaimer • • Privacy • Cookies | Services • • Us | Follow us:

http://www.intertek.com/polymers/testlopedia/dielectric-strength-astm-d149/

1/1