Sap2000 Nonlinear Dynamic Analysis 5w735y

Workshop Nonlinear Dynamic Analysis in SAP2000 Manish Kumar Post-doctoral Associate Civil, Structural and Environmental Engineering University at Buffalo, State University of New York (SUNY) EERI Engineering Workshop Manish Kumar

1/12

Outline • • • • •

Nonlinearity Modal analysis Pushover analysis Response spectrum analysis Response history analysis

EERI Engineering Workshop Manish Kumar

2/12

Geometric nonlinearity

Source: wiki.csiamerica.com

EERI Engineering Workshop Manish Kumar

3/12

Geometric nonlinearity • P-Delta – Geometric stiffness matrix formulated at beginning – Computational efficient – Appropriate when vertical loads do not vary substantially during analysis

• P-Delta + large deformations – Stiffness matrix updated at each step – Computationally expensive – Appropriate when vertical loads vary substantially during analysis

EERI Engineering Workshop Manish Kumar

4/12

Geometric nonlinearity • Two ways to include P-Delta effects – Create static nonlinear case for each load combination • Only for static analysis

– Create initial P-Delta for anticipated gravity loads • Use modified stiffness from this for all analysis • Can be used for modal, static, and dynamic analysis

EERI Engineering Workshop Manish Kumar

5/12

Material nonlinearity • Concentrated yield – Appropriate for frame – Assign at the member ends – Discretize using “hinge overwrites to get better convergence

• Distributed plasticity – Computationally expensive EERI Engineering Workshop Manish Kumar

6/12

Modal analysis • Eigen vectors • Ritz vectors – For dynamic analysis – More accurate

EERI Engineering Workshop Manish Kumar

7/12

Pushover analysis Create the computational model

Define a nonlinear static load case

Run the analysis

Review results

• Create SAP2000 model • Define hinge properties and assign it to frame elements • Define load pattern applied during pushover analysis

• Define nonlinear static load case in the desired direction • Define nonlinear analysis option through "other parameters"

• Run the analysis for modal, DL, LL, and pushover case

• Review pushover curve • Review individual hinge results • Review sequence of hinge formation in the structure EERI Engineering Workshop Manish Kumar

8/12

Time-history analysis • Modal

• Direct integration

– Linear & nonlinear

• Modal nonlinear analysis

– Also called fast nonlinear analysis (FNA) – Appropriate for limited nonlinear in at concentrated locations (e.g, structures with dampers and baseisolators)

– Linear & nonlinear – Appropriate to capture large nonlinear response of structures (e.g, collapse simulation)

EERI Engineering Workshop Manish Kumar

9/12

Time-history analysis • Modal

• Direct integration

– Linear & nonlinear

• Modal nonlinear analysis

– Also called fast nonlinear analysis (FNA) – Appropriate for limited nonlinear in at concentrated locations (e.g, structures with dampers and baseisolators)

– Linear & nonlinear – Appropriate to capture large nonlinear response of structures (e.g, collapse simulation)

EERI Engineering Workshop Manish Kumar

10/12

Local axis • Local axis 1 is always the longitudinal axis • The default orientation of the local 2 and 3 axes is determined by the relationship between the local 1 axis and the global Z axis:

– The local 1-2 plane is taken to be vertical, i.e., parallel to the Z axis – The local 2 axis is taken to have an upward (+Z) sense unless the element is vertical, in which case the local 2 axis is taken to be horizontal along the global +X direction – The local 3 axis is always horizontal, i.e., it lies in the X-Y plane EERI Engineering Workshop Manish Kumar

11/12

Thank You! Questions? [email protected] www.manishkumar.org

EERI Engineering Workshop Manish Kumar

12/12